Wahoo Industries Double Rod Rigger (Item 108)
The Double Rod Rigger has the same ability of a traditional rod rigger to fish either starboard or port and still have the option to fish another line from the stern.
|Double Rod Rigger||21'' x 11'' x 2''||2 lb.||Anodized||$79.95 USD|
Wahoo Industries Double Rod Rigger, made with tough 60 series aluminum, has the same ability of a traditional rod rigger to fish either starboard or port and still have the option to fish another line from the stern.
4.5 Stars based on 7 reviews
April 26, 2017
Does the job
Glue or tape the black end protectors on or you'll be loosing them
By John Festa
Clearwater Beach, Fl.
April 24, 2017
Good but could be better
Works well but could be a little thicker for a better fit in the rod holders. Lost one because it stuck to the rod and fell in the gulf. My buddy was.not ready for it when he pulled the rod and over it went.
ConsA little thin in the rod holder
October 29, 2015
Great for trolling
Works great for trolling for Rockfish.
September 5, 2015
Works no complaints
Can maneuver easier now I useing this
ProsEasy to use
June 22, 2014
Works great except...
Works great to troll two lines on my small boat. Only issue is that my older Ande stand ups have a bigger butt and don't slide in and out. I ripped off the rubber seal on the rigger and it works great now, no hang ups (especially leaning halfway over the gunnel). I just make sure to have all my reels clipped in.
January 17, 2014
I think it must be on every boat, when trolling
May 24, 2013
Great way to add rod storage!
If you're tired of having fishing poles laying on the deck this is a great way to add rod storage to any boat. I like the ability to fish one pole long on the surface and a chunk closer to the boat out of the same rod holder. It is also convenient to have when using a bait cutting station that occupys a rod holder. These are high quality rod holders built to last!
Prosadded rod storage convenience of fishing 2 rods from 1 holder
5 Questions & 5 Answers
from Charleston, SC asked:
February 14, 2017
Are there lanyards attached to this rod holder that I am seeing in the picture?
The Wahoo Industries Double Rod Rigger (Item 108) does not come with the lanyard as shown in the picture. The picture is just an example photo of what it will look like with a lanyard attached.
on February 15, 2017
from New York asked:
September 2, 2016
The double rigger appears to insert into an existing rod holder with a 1.5" opening... What stops the double rigger from turning/spinning ...is it locked into the existing rod holder somehow to maintain the two rod positions?
The pin that is in the rod holder fits into the slot on the bottom of the double rigger.
on September 2, 2016
from Ohio asked:
September 7, 2015
What is the size of the butt end that fits in my rod holder? Example, is it 1.5" diameter x 9" long?
The diameter is 1.5" and the length is 8.5"
on September 30, 2015
from PA asked:
September 19, 2012
is it $69.95 for one or $69.95 for a pair?
It is $69.95 for one.
on September 20, 2012
from email@example.com asked:
July 13, 2012
what size rod butt will it hold
The pipe has a 2" O.D. and will accommodate almost any rod.
on July 17, 2012
Starting at $69.00
$59.99 Our Price: $28.95
Starting at $84.99
Starting at $16.99
Our Price: $6.99