Shoals Harpoons has introduced a Harpoon Kit for those who want to make a quality one piece harpoon in any length they choose. They supply the head piece ?end piece / carabiner and pike. You need to supply the pipe (it is recommended to use an aluminum pipe which is schedule 40 conduit ? inches) this is available at major retailers and electrical supply stores and is very economical ?rigid and lightweight. All our components are made locally here in New England --- we use only the finest raw materials when making our harpoon components. We supply 3/8 inch stainless steel button screws which secure the head and rear section pieces of the harpoon. You need to measure 1 inch from the end of the pipe on both ends --- mark where the screws will fit the pipe and drill a starter hole ---3 button socket screws secure each end piece of the harpoon in place.
Kit includes the following parts:1 Harpoon brass head approx. 1lb 6oz ( weighted to throw at fish under water) drilled and tapped in 3 places ---head is machined to fit inside schedule 40 aluminum conduit harpoon shaft 1 Harpoon end cap and carabiner ?with unique machined piece that holds carabiner included (to clip on main line) ---machined to fit inside schedule 40 aluminum conduit harpoon shaft 1 Stainless Pike 3/8 inch ?approx. 18 inches long ----screws into end of harpoon head 6 -- Button socket head stainless steel screws ---- secures end cap and harpoon head
Kit includes the following parts:
